Advanced oxide and metal etcher

Jälki-ilmoitus #62682
Hankinnan arvo
3 168 000 €
Voittaja
LAM Research
Julkaistu

Hankinnan tiedot

Ostaja
TEKNOLOGIAN TUTKIMUSKESKUS VTT OY
Ilmoituksen numero
62682

Hankinnan kuvaus

Advanced oxide and metal etcher The object of the procurement was an advanced plasma etch cluster tool for etching metal and thin-film layers on 200 mm silicon wafers used in the semiconductor industry. VTT required a reliable, production-worthy tool capable of supporting at least four process chambers and meeting the other technical requirements described below. DIRECT AWARD, Section 40(2)(2) of the Finnish Procurement Act (1397/2016) The procurement was carried out as a direct award in accordance with Section 40(2)(2) of the Finnish Public Procurement Act. According to Section 40(2)(2) of the Act on Public Procurement and Concession Contracts (1397/2016), only a certain supplier may implement the procurement for a technical reason or for a reason related to the protection of an exclusive right. A further condition is that there are no reasonable alternatives or substitute solutions and that the absence of competition is not due to an artificial narrowing of the terms and conditions of the procurement. VTT acquired an advanced plasma etch cluster tool for the etching of metal, dielectric and other thin-film layers on 200 mm semiconductor wafers. The equipment was intended to support a broad range of research, development and pilot-line processes, including metal and high-k material etching. A single cluster platform was required to provide production-level process reliability, uniformity and reproducibility while retaining the process flexibility required in a research and technology organization. The tool configuration was based on the technical needs arising from the intended use. The mandatory capabilities included: (i) advanced chamber cleaning and conditioning, comprising waferless cleaning between process wafers and cleaning or passivation with cover wafers for materials that form less volatile by-products; (ii) a wide process-power range and etch-rate tunability through atomic layer etching (ALE), low-voltage pulsed-bias etching and steady-state processing; (iii) dual-zone chuck heating and dual-zone coil or power control for optimization of within-wafer etch uniformity; and (iv) at least three load ports and a cluster architecture capable of supporting at least four process chambers. These capabilities were required to control cross-contamination, stabilize sensitive processes, process materials with different volatility and thickness characteristics, and avoid the cluster becoming a capacity bottleneck as additional process chambers were introduced. VTT conducted a market survey to identify suppliers of advanced etch cluster systems for semiconductor processing. The survey included direct discussions with tool manufacturers, technical evaluation of available solutions and a review of publicly available product information. Based on the market survey, LAM Research was the only identified supplier whose solution met all mandatory technical requirements simultaneously. In particular, the LAM 2300 platform with Kiyo 45 and Flex 45 cha…

Voittajat ja hankinnan osat

Hankinnan osa 1

Advanced oxide and metal etcher

Voittaja

The object of the procurement was an advanced plasma etch cluster tool for etching metal and thin-film layers on 200 mm silicon wafers used in the semiconductor industry. VTT required a reliable, production-worthy tool capable of supporting at least four process chambers and meeting the other technical requirements described below. DIRECT AWARD, Section 40(2)(2) of the Finnish Procurement Act (1397/2016) The procurement was carried out as a direct award in accordance with Section 40(2)(2) of t…

Muut ostajan hankinnat Hae kaikista hankinnoista

Lähde: HILMA-jälki-ilmoitus 62682. Alkuperäinen ilmoitus (avautuu uuteen välilehteen)